Working principle and common faults of setting machine

Drying oven made by setting machine manufacturer. It should dry just fine. Because the socks produced now are thicker. Therefore, the effect of drying, in order to make the drying effect a little better, it is necessary to have a higher quality of steam, first of all, there should be enough steam to ensure the first time of drying, the first time of drying directly affects the drying effect of the second time, the quality of a dry is determined by the amount of steam. So: steam should not only have pressure, but also have enough steam flow, and then the less water in the steam, the better. In order to ensure the safe and normal operation of the molding machine, the following points must be done:

one Regular cleaning of equipment: gear, chain, belt disc in the transmission part, whether there is dust, or socks. Should be checked and cleaned daily, butter area is accumulated? Check the wear condition of each belt once a day, each shift must be on the rail guide, sock plate seat, even the iron once. Each gear reducer should change oil once every six months.

two Each chain, increase the strength of the weekly check: socks board movement of two chains, as tight as possible. It is better to loosen the chain of other parts manually. (No beating)

3. The filter cover of the drying oven and the heater net cover and the net cover of the first drying fan must be cleaned once a month, and according to the different raw materials of socks to decide the length of cleaning time, the production of cotton socks should be checked once a week.

Four. Try not to drive the stop button during the operation of the machine to ensure the normal running speed of the machine. Such as variety change life too late to do, can reduce the speed, or increase personnel, do not stop at will halfway.

Five. In case of failure, the operation condition of the machine before the broken car should be understood in detail to improve the repair speed and reduce the parking time, so as to ensure the operation rate.

Six. The operation rate of the car is determined by the quality of the operator and the car. A large part of the stop is caused by the socks accidentally falling on the machine. Reducing the number of socks falling can greatly improve the operation rate of the equipment. (This is especially important).