Six steps to adjust the front machine

Step on the quick retreat pedal. 6 If improper operation or equipment abnormality occurs during operation. Return the device to its original state.

Often because of a little deviation, cause a great impact. Therefore, I will pay attention to the details before the test. The specific steps for adjusting the machine before the test include:

Before the machine adjustment.

1 the shoe upper cover on the shoe last, and make the toe part of the help into the opening of the first claw, step on the start switch (left foot step switch) to make the first claw clamped vamp.

Step on the start switch again, 2 PUT the remaining sides into the opening of the two, three and four claws respectively. Then let go so that two, three and four claws clamp the upper, and then the platform rises to tighten the upper.

If it is not ideal, the knee can gently touch the half-back switch, 3 check the vamp tightening condition. Adjust the position of the shoe last under the upper, so that the upper support condition to achieve the best.

Or pull the two control handles with both hands at the same time, 4 press the start switch again. When the big seat drops (or sweeps the knife forward to the pre-alignment position), the equipment will automatically complete the alignment action.

All parts of the machine automatically return to the initial state. 5 A work cycle ends.